Edge GUARD/DEPTH GAUGE SERIES Manual do Utilizador descarregar pdf (Página 14)

Maintaining TriLink Saw Chain

CHECKING AND ADJUSTING

After sharpening a chain’s cutters 3 or 4 times with a round le, it is

necessary to check the height of the depth gauge.

To do this:

1. Place depth guide tool over chain, near mid point of guide bar, so that the

chain’s depth gauge extends through slot.

2. If the cutter’s depth gauge extends above the slot in the depth gauge, le

the cutter’s depth gauge down with at le until it is level with the depth gauge

tool. Make sure to keep the round prole on the front of the cutter’s depth gauge.

The depth gauge must be led down, as your leading edge is shortened, to

allow the leading edge to catch the cutting surface. A depth gauge that is not

maintained will cause insufcient cutting. However, if the depth gauge is led

too low it will cause a rough cut and rise the chances of kickback.

.025"

(.6mm)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sem comentários

Edge GUARD/DEPTH GAUGE SERIES Manual do Utilizador Página 14