Edge CTS Guia do Utilizador descarregar pdf (Página 15)

Edge Products ______________________________________GM Juice-Attitude CS/CTS

Power Gains (2007.5-2010 GMC Duramax LMM)

Level Horsepower Torque

LEVEL 0 0 0

LEVEL 1 30 60

LEVEL 2 40 80

LEVEL 3 50 90

LEVEL 4 60 100

LEVEL 5 80 130

LEVEL 6 (See Hot Unlock section) 85 200

Final Inspection

Recheck all connections for a properly secure installation. Using the supplied wire ties,

secure the wiring harness to prevent possible damage.

Start the engine. The engine should start and run like a stock truck. If the engine does not

start or run properly, turn off the motor, remove the keys from the ignition, wait 2 minutes

then remove the juice module and inspect the pins inside all connectors. Straighten pins or

clear foreign material from the pins and connector surfaces, then re-install the connectors.

If failure conditions still exist, contact your dealer or Edge Products, LLC. When trying to

restart, make sure that the key has been turned off for at least 10 seconds before cranking

the engine.

Install and Attach the EGT Probe

It is necessary to tap a small hole into your exhaust manifold to insert the EGT sensor. The

EGT probe must be mounted before the turbo for the Juice safety features to operate

properly.

WARNING When installing the EGT Thermocouple, wear eye protection and

protective clothing to protect from getting metal chips in your eyes. Also, since exhaust

manifolds can be very hot, allow the engine to cool before drilling. When working under

the vehicle, make sure the park brake is set. If the vehicle must be raised, carefully follow

the stand and vehicle safety guidelines for placement and use of jacks and stands.

CAUTION: One effective way to avoid metal fragment contamination in your engine

manifold is to apply grease in the tip of the drill bit and threads of your tap tool when

drilling/tapping the hole in your manifold. Reduce pressure on the drill when the drill

breaks through the manifold wall to reduce risk of pushing metal chips into the manifold.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Chrisfoomo 26 Apr 2024 | 22:39:06

Hello, im noob :)

Edge CTS Guia do Utilizador Página 15