Edge CTS Guia do Utilizador descarregar pdf (Página 16)

Edge Products ______________________________________GM Juice-Attitude CS/CTS

1. Obtain a 1/8” tapered National Pipe Tap (NPT) available from your hardware store.

Drill a 21/64” (5/16” optional) hole through the manifold wall, and then use the pipe tap

to cut the threads. Follow the instructions provided with the tap. The pipe tap is tapered,

so you will only want to turn the tap until the bottom threads of the tap are slightly

deeper than flush with the inside of the exhaust manifold wall. Use caution not to tap too

deep since this would cause the thermocouple fitting and probe to seat too deep. (tap

deep enough to allow 3+ full threads of fitting to seat in manifold)

2. After the manifold has been drilled and tapped, remove the fitting from the

Thermocouple and install by tightening the tapered thread end into the manifold with a

9/16” end wrench. (Ideally the tip of the fitting would be less than or flush with the

inside of the exhaust flow path.) Tighten the fitting so that it is securely seated. Then

install the probe into the fitting, and tighten the top nut of the fitting just tight enough to

keep the probe firmly mounted. Make sure that the probe cable is positioned to allow

best path and minimal bending, for cable routing to the top of the engine compartment.

EGT PROBE INSTALLATION

NOTE: The probe will move approximately

90 Deg. clockwise in the direction the nut is

tightened. Before fully tightening the nut,

make sure the cable starts 90 Degrees from

the final resting position. When tightened,

the cable will be correctly positioned.

CAUTION: Do not bend the probe after installed. If needed, loosen the probe nut, adjust

the probe, and re-tighten. Bending the probe tubing will result in a faulty probe.

EGT probe inserted into

exhaust manifold.

EGT

robe

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Chrisfoomo 26 Apr 2024 | 22:39:06

Hello, im noob :)

Edge CTS Guia do Utilizador Página 16