
Edge Products ______________________________________GM Juice-Attitude CS/CTS
19
Attach the EAS JAB (Juice-Attitude Bridge)
The JAB is part of the EAS (Edge Expandable Accessory System). It can be used with an
EAS EGT if you have one installed. The expandable Accessory system allows starting with
one sensor and adding more as needed. The components connect to each other using keyed
guide slots and locking nuts on each accessory. The user might start with an EGT sensor
and then have flexibility to add additional sensors (including, but not limited to, a 2
nd
EGT
sensor, JAB Attitude Bridge, Wide Band O2 sensor, Fuel Rail Pressure sensor and Turbo
timer sensors, etc.).
If you have an EAS EGT installed, adding an EAS JAB (or another expandable accessory)
is accomplished by removing the Terminator cap and attaching the additional accessory in
its place in a daisy chain manner. Remove the Terminator Cap by turning the lock nut
counter clock-wise. (The lock nut is designed to lock and requires a firm grip and force to
unlock.) Attach the new accessory by aligning the guide keys in the matching connectors
and turning the locking nuts to secure. Then replace the Terminator Cap on the end of the
new accessory and secure the lock nut. Use a nylon tie to secure the JAB to the firewall
flange along with the EAS EGT. Proceed to connect the JAB cable to the Juice harness.
1. Use the following instructions to install and attach the EAS JAB to your vehicle.
Note: Connect the Expandable JAB sensor, Terminator cap and EAS cable to each other by
aligning the guide keys in the matching connectors and turning the lock nut until a snap is
felt in the lock nuts. Hang the Expandable connector assembly as shown, using the supplied
nylon ties.
EAS Cable
attaches to the
JAB Sensor T and
CS/CTS Device
EAS JAB
Terminator Cap
Hello, im noob :)