Edge CTS Manual do Utilizador descarregar pdf (Página 12)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TRANS FLUID

SENSOR

COVER PLATE

TRANSMISSION HOUSING

Figure 11

2) Use the 21/64” drill bit to

drill a hole perpendicular to the

face you are drilling into.

DRILL BIT

Figure 12

3) Tap the hole using the 1/8”

NPT pipe tap. See Figure 13.

TAP

HOLE

Figure 13

4) Clean the area in and around

the tapped hole and make sure it

is free of burrs and metal frag-

ments.

5) Apply a thread sealing com-

pound to the sensor threads, and

insert it into the tapped hole.

Use the 1/2” wrench (Temp) or

the 13mm wrench (Pressure) to

tighten until snug. (Do not over

tighten. Avoid stripping the

threads.)

INSTALL THE ADAPTER

Now that the Universal Sensor

Input Device and the Tempera-

ture/Pressure sensors are se-

cured, the Harness Adapter can

be added to connect the two.

Temperature sensor adapter:

1) Locate the Temperature

Adapter Harness included with

the sensor. See Figure 14.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Edge CTS Manual do Utilizador Página 12