Edge CTS Manual do Utilizador descarregar pdf (Página 15)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

3)Coil unused wire:

Single wire install-coil both the

BLACK and RED wires on the

adapter.

Double wire install-coil only

the RED since the BLACK and

YELLOW wires are needed.

4) Connect the wires:

Single wire install-connect

the YELLOW wire lead to the

proper location on the sensor.

Double wire install-connect the

YELLOW wire to the sensor

output signal, and the BLACK

wire to the ground signal.

Triple wire install-connect the

YELLOW wire to the sensor

output signal, the BLACK wire

to the ground signal, and the

RED wire to the 5V reference

signal.

5) Double check all connections

to ensure that they are making

good contact. If possible, use a

multi-meter to check continuity.

6) Plug the adapter connector

into one of the device connec-

tors.

EAS CONNECTOR

ADAPTER CONNECTOR

Figure 21

The ﬁ nal assembly of each type

of installation should resemble

one of the following Figures

(22-24).

HOLE IN FIRE WALL

ADAPTER SENSOR

Figure 22 - Single

HOLE IN FIRE WALL

ADAPTER SENSOR

Figure 23 - Double

HOLE IN FIRE WALL

ADAPTER SENSOR

Figure 24 - Triple

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comentários a estes Manuais

Sem comentários

Edge CTS Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Monitor tátil Edge CTS