Edge CTS Manual do Utilizador descarregar pdf (Página 29)

MYSTYLE SOFTWARE

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

CUSTOM MAPPING

If you chose to install a sensor

that is not called out as a default

sensor, you may chose to create

custom mapping.

1) Choose the custom map-

ping option according to your

type of sensor. The two choices

are:

-Voltage (V)

-Resistance (ohms)

Most sensors will have data

sheets that contain a chart of

values that you can use to input

into the Mystyle chart.

For example, refer to the chart

in Figure 49. In the case of a

Temperature Sensor (Therm-

istor), the chart will have a

temperature value (Usually in

degrees Celsius) that corre-

sponds to a resistance value.

NOTE: It is important that

you label your units properly.

For example, if your chart

gives you degrees in Celsius,

make certain that the Unit of

Measure you input matches

that value type.

Figure 48

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Edge CTS Manual do Utilizador Página 29