Edge CTS Manual do Utilizador descarregar pdf (Página 19)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

FUSE #1 INSTALLATION

1) Locate the YELLOW wire

labeled “VBAT” on the Main

Turbo Timer device and route it

to the appropriate fuse box loca-

tion according to the informa-

tion in Figure 31.

2) Remove the fuse listed in

Figure 31 and replace it with the

appropriate fuse adapter. (Keep

in mind the orientation.)

3) Plug the end of the Fuse

adapter into the YELLOW

“VBAT” line you had routed in

step 1.

(NOTE: Make sure that all

wires are routed within the

fuse box to avoid the fuse box

lid.)

4) Find the best location for the

wire to come out of the fuse box

and minimize possible crushing

when the lid is closed.

You are now ready to install the

second fuse if applicable.

TRUCK YEAR FUSE BOX FUSE (amps) ORIENTATION

2001-2002 Under Hood TBC (10amp) Rear

2003-2007 Under Hood TBC BATT (10amp) Rear

2007.5-2011 Under Hood IPC (10amp) Rear

FORD

1994-1997 Steering Column 16 (15amp) Bottom

1999-2001 Steering Column 4 (10amp) Left

2002-2003 Steering Column 10 (10amp) Left

2004-2007 Steering Column 2 (10amp) Left

2008-2010 Under Hood 30 (10amp) Front

2011 Under Hood 46 (10amp) Left

DODGE

1998.5-2002 Under Hood

A/C CLUTCH (10amp) Front

2003-2005 Under Hood 16 (10amp) Rear

2006-2009 Under Hood 23 (10amp) Left

2010 Under Hood M26 (10amp) Front

2011 Under Hood M27 (10amp) Right

Figure 31 - Fuse 1 Location and Orientation

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comentários a estes Manuais

Sem comentários

Edge CTS Manual do Utilizador Página 19

Comentários a estes Manuais

Manuais e produtos relacionados com Monitor tátil Edge CTS