Edge CTS Manual do Utilizador descarregar pdf (Página 23)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

E A S - S T A N D A R D E G T

EAS - STANDARD EGT

Probe

Main

Cable

The non-expandable accessory system (Standard EGT Probe) pro-

vides a single sensor allowing the user to monitor only one EGT

parameter.

NOTE: The EGT sensor can not be chained and if you wish to

add expandable capability, you will need to purchase a new ex-

pandable EGT.

Figure 38 - STANDARD

FITTING AND PROBE INSTALLATION

These installations are similar to the Expandable probe installation.

Refer to “FITTING INSTALLATION” and “PROBE INSTAL-

LATION” sections under the “EGT CONNECTION” section for

proper install instructions.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Sem comentários

Edge CTS Manual do Utilizador Página 23