Edge CTS Manual do Utilizador descarregar pdf (Página 8)

HARDWARE INSTALLATIONS

Installation Instructions

8

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

allow the engine to cool before

drilling. When working un-

der the vehicle, make sure the

parking brake is set.

CAUTION: One effective

way to avoid metal fragment

contamination in your engine

manifold is to apply grease

in the tip of the drill bit and

threads of your tap tool when

drilling/tapping the hole in

your manifold. Reduce pres-

sure on the drill when the drill

breaks through the manifold

wall to reduce risk of pushing

metal chips into the manifold.

Required Tools

- Drill

- 1/8” drill bit or similar size

(for pilot hole)

- 21/64” (best size) or 5/16”

drill bit

- 9/16” wrench or socket

- 5/8” open end wrench

- 1/8”-27 NPT Thread Tap

- Phillips screwdriver

- 5/16” or 8mm wrench

FITTING INSTALLATION

1) Obtain a 1/8” National Pipe

Tap (NPT) available from your

hardware store.

2) Drill a 21/64” (5/16” op-

tional) hole through the exhaust

manifold wall.

3) Use the pipe tap to cut the

threads in accordance to the

pipe tap manufacturer’s instruc-

tions and recommendations.

4) Remove the ﬁ tting from the

Thermocouple end and install

by tightening the tapered thread

end into the manifold.

(Figure 6)

Figure 6 - INSTALL FITTING

5) Tighten the ﬁ tting so that it is

securely seated.

PROBE INSTALLATION

1) Install the probe into the ﬁ t-

ting, and tighten the top nut of

the ﬁ tting just tight enough to

keep the probe ﬁ rmly mounted.

(Figure 7)

NOTE: Ideally the tip of the ﬁ t-

ting would be less than or ﬂ ush

with the inside of the exhaust

ﬂ ow path. (Figure 7)

Exhaust Manifold Wall

Fitting

Tapped Hole

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comentários a estes Manuais

Sem comentários