Edge CTS Manual do Utilizador descarregar pdf (Página 7)

HARDWARE INSTALLATIONS

7

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

The JAB (Juice to Attitude

Bridge) allows you to connect

your Edge Juice Module to your

CS or CTS device. This allows

your CS or CTS to communi-

cate with and control your Juice

Module. Your CS/CTS will use

the device to talk to your Juice.

The following are instructions

on how to connect the JAB to

the Juice module.

1) Unplug your old Attitude

from your Juice module. To do

this lightly lift up the small tab

with a small screw driver and

lightly pull the connectors apart.

(Figure 5)

NOTE: Be careful not to dam-

age the lock during un-install.

Figure 5 - ATTITUDE DIS-

CONNECT

2) Remove your old Attitude

from the vehicle.

3) Locate the connector at the

end of the JAB and plug it into

the corresponding Juice connec-

tor.

EGT stands for Exhaust Gas

Temperature. EGT Sensors are

offered on all 3 of our product

platforms:

*On the Juice it can be added as

a second EGT sensor (besides

the probe that directly connects

to the Juice itself).

*On the Evolutions it is

recommended that it be used

with vehicles running diesel

engines due to their potential of

getting extremely hot.

*On the Insight, it can be used

to monitor everyday vehicle

temperatures as well as those

vehicles that are pushed to their

limits.

WARNING When in-

stalling the EGT Thermocou-

ple, wear eye protection and

protective clothing to protect

from getting metal chips in

your eyes. Also, since exhaust

manifolds can be very hot,

JUICE TO ATTITUDE CONNECTIONS

EGT CONNECTIONS

Snap Latch

Screw Driver

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comentários a estes Manuais

Sem comentários