Edge CTS Manual do Utilizador descarregar pdf (Página 14)

HARDWARE INSTALLATIONS

Installation Instructions

14

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

3) Route the remaining connec-

tor and wire to the Universal

Sensor Input Device.

4) Plug the adapter connector

into one of the device connec-

tors. (See Figure 16 pg.13)

UNIVERSAL INSTALLATION

This section explains how to in-

stall sensors that are not sold by

Edge Products. Keep in mind

that this section is generalized,

and does not give exact infor-

mation on how to install the

sensor itself. You will however,

be instructed on how to connect

a particular type of sensor to the

Universal Sensor Input Device

via the adapter cables included

in main kit.

PARTS INCLUDED:

(1) Universal Input Device

(2) Adapter Harnesses

(1) Zip-tie Packet

TYPICAL SENSORS

There are 3 basic types of sen-

sors. The sensors you will be

monitoring may come with 1, 2,

or 3 connections that will need

to be connected to a particular

adapter wire.

Each adapter wire is labeled and

color coded. See Figure 19

Black (GROUND)

Red (POWER)

Yellow (SENSOR)

Figure 19

NOTE: The adapter wire ends

are blunt cut. It is up to the

user to ﬁ nd the best method

of connecting the wire ends to

the sensor. We suggest using

off the shelf hardware such as

bullet, spade, or butt style con-

nectors.

INSTALLATION STEPS

NOTE: First install the Main

EAS Cable Assembly accord-

ing to the instructions located

on pages 5 and 6 then continue

with the following steps.

1) Find the best location for the

sensor. Install the sensor ac-

cordingly.

2) Locate one of the 3 Pin

adapters. (Figure 20)

Figure 20

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comentários a estes Manuais

Sem comentários