Edge CTS Manual do Utilizador descarregar pdf (Página 26)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

F I N A L I N S P E C T I O N

FINAL INSPECTION

1) Recheck all connections for

a properly secure installation.

Using the supplied wire ties,

secure the wiring cabling to pre-

vent possible heat damage from

hot engine surfaces.

2) Start the engine. The engine

should start and idle like a stock

truck. If the engine does not

start or run properly, turn off the

engine. Remove the keys from

the ignition, and re-check all

connections. Make sure all con-

nectors are fastened tightly. If

you continue to have problems,

contact your dealer or Edge

Products, LLC.

Figure 44 - EAS Designs

If more than one EAS device is

plugged together, use the long

zip ties provided in the packet

to connect their bodies together

as shown in Figure 44. The

New body design has two slots

that allow the zip ties to be

seated.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Sem comentários

Edge CTS Manual do Utilizador Página 26