Edge CTS Manual do Utilizador descarregar pdf (Página 24)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

ROUTING THE MAIN CABLE

The Main Cables for the Ex-

pandable and Non-expandable

options must be routed through

the vehicle’s ﬁ re-wall.

1) Locate the rubber grommet

on the driver side ﬁ re-wall.

Figure 39 - ENGINE

COMPARTMENT VIEW

2) Feed the end of the Main

Cable through the rubber grom-

met. (Figures 39 & 40)

CAUTION: Make sure con-

nector is not damaged dur-

ing the routing process. The

connector lock mechanism is

critical and cannot be dam-

aged.

Figure 40 - FIRE WALL

3) Route the cable from below

the dash up to the lower left

corner of the driver side wind-

shield. (Figure 41)

Figure 41 - ROUTING

4) If needed, remove side pan-

els to help see while routing.

C O N N E C T I N G T O T H E C S / C T S

CONNECTING TO THE CS/CTS

EAS Connector

CS/CTS

Connector

Fire Wall

Grommet

Engine Side

Cab Side

Grommet

CS/CTS

Connector

EAS Assembly

To EAS DEVICE

Main Cable - Routed

Grommet

Fire-wall

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comentários a estes Manuais

Sem comentários

Edge CTS Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Monitor tátil Edge CTS